Antall besøk:

MOD

Wenger Classic 07 MOD

 

Here is a Classic 07 that had the red handles on, it now got the translucent orange on.

The factory in Delemont got a good selection of colors for the Classic range with the inlay emblem. This is an important detail - the emblem is an inlay, this is not always easy to see since it is perfectly made on the surface.

 

The knife got the main Wenger functions!

 

I also put in a Victorinox mini screwdriver in the corkscrew, perfect fit.

To change the handles was easy, i used a thin steel rod into the tweezer and toothpick holder. Lifted up gently - then use a flat metal tool and lift gently.

I used a wood vice to snap the scales on but first lift up the corkscrew since it is wider than the scale. Make sure the handles do not warp after.

Fikk fargen mest mulig lik på dette bildet. Synes denne var fin! Var relativt enkelt å bytte skjefteplatene.
Ingen problem å skifte skjefteplater på Evolution også, sett inn en rund stål stang inn i åpningen for tannpirker og pinsett, deretter vippe forsiktig opp. Så bruk en flat metall ting under skjeftene og vipp opp til de er av. Når de nye skulle på så brukte jeg ikke en tvinge siden Evolution ikke har en flat form. Men en tang og tykt lær gikk greit. Klem forsiktig og så er de på. Bruk en varsom hånd!
It is important not to use to much force when one put on the New scales, to much force will damage the SAK. The rivets and mechanism may get damaged. It is very little strength needed to put them on.

Update new MOD

I replaced the red scales on another Classic 07 with yellow. It is nice!

Skriv en kommentar: (Klikk her)

123hjemmeside.no
Antall tegn tilbake: 160
OK Sender...
Se alle kommentarer

| Svar

Nyeste kommentarer

29.11 | 21:40

Hi, thank you very much for question. I am not sure. I know there are modders that manage unbelievable things. BR

...
29.11 | 17:26

Hi again trond. Was wondering if you could put scissors from the Classic SD onto a tinker? Thank you

...
26.11 | 16:24

Hi, thank you very much for question. The brass rivets/pins should be the same on the 91mm if same age. There could be some diff. tolerances.
BR Trond

...
26.11 | 16:16

Hello Trond. Are the copper rivets on the Victorinox Huntsman and the Deluxe Tinker the same? Thank you

...
Jeg liker denne siden
Du liker denne siden
Skriv kommentar
Hei!
Prøv å lage din egen hjemmeside som jeg.
Det er enkelt, og du kan prøve det helt gratis.
ANNONSE